Correct steps for the deformation of the plate and frame filter press frame

Long-term use of plate and frame filter press equipment may face the problem of frame deformation, how to deal with it correctly and effectively? The following introduces the commonly used treatment methods:

1. To solve the problem of denaturation of the frame of the plate and frame filter press, first of all, we must see whether the anchor screw of the filter press is tight, one end of the filter press check plate is tightened according to the normal screw, and the screw at the bottom end of the cylinder seat must not be tightened.

2. After cleaning and installing the filter plate and filter cloth of the plate and frame filter press, observe the direction of tilt and bending of the frame. Arrange the filter plates neatly in the direction of the stop plate, bend the beam to the left, leave fifteen to twenty filter plates at the bend and pull them at a 45-degree angle, lean hard to the right, and the remaining other filter plates are discharged neatly to the end of the pressing plate. Press the start button tightly, press the filter plate, at this time the 45 degree angle filter plate squeezes the force to the right, pay attention to pressure control, and relax the filter plate after reaching the balance point.

If the rack is still bent after doing so, it is recommended to repeat the above operation five to six times until the rack returns to normal. If you still can't get the rack back to normal, it is recommended to seek further help from a professional manufacturer.